Full Boar FBDDP-7500, Инструкция по эксплуатации

Страница: 22 / 28

22
MAINTENANCE
WARNING!
Ensure the drill press is switched off and disconnected from the power
supply before performing any maintenance or cleaning.
• Ball bearings are packed with grease at the factory. No further lubrication of bearings is
required.
• Lubricate all moving parts periodically. Wipe the column, table and base with an oily cloth
to minimise corrosion.
• Keep air vents clean of dust and dirt.
• Remove dust and dirt from the drill press regularly with a soft cloth, brush or compressed
air.
• If the power cord is damaged, have it replaced by an electrician or a qualified power tool
repairer.
• Regularly check that all bolts, screws and nuts are securely fixed as these could work loose
during normal operation.
Note: Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the drill press by an unauthorised person or by mishandling of the pedestal drill.
Changing the V-belt
The V-belt of the bench drill is a consumable part and should be replaced when worn.
Replace the V-belt as follows:
1.
Run the machine while slowly setting the speed control lever (2) to the minimum speed.
2. Switch the machine off, then pull out the power plug.
3. Set the speed control
lever (2) to the maximum
speed setting to slacken
the V-belt (Fig. 37).
4. Undo the screws to open
the V-belt cover (22)
(Fig. 38).
IMPORTANT! Never let the bench drill run when the V-belt cover is open. Always
pull out the power plug before opening the cover. Never touch the V-belt when it is
rotating.
R.P.M
Fig. 37 Fig. 38