Full Boar FBDDP-7500, Инструкция по эксплуатации

Страница: 19 / 28

19
ADJUSTMENTS (cont.)
4.
Insert the drift key (34) into the slot and tap firmly with a
soft face hammer until it releases, taking care as you do
so to ensure that the chuck does not land on the floor.
(Ensure the chuck jaws are wound all the way up to prevent
damage) (Fig. 32).
5.
Place tapered bit into the spindle hole, twisting and
pushing upward until bit is snug (Fig. 33).
6. Place block of wood on the drill table (18) and raise up
table until the tapered bit is firmly into the spindle.
Setting the speed
The operating speed of the machine is infinitely adjustable.
IMPORTANT! Speed adjustments are allowed only when the motor is running.
1. Slowly and steadily move the speed control lever (2) while the machine is in idle mode
(Fig. 34).
Pull the lever (2) towards the front for higher speeds or push away for a slower speed.
2.
The set speed is shown
on the digital display (16)
in revolutions per minute
(Fig. 35).
R.P.M
R.P.M
Fig. 32
Fig. 33
Fig. 34 Fig. 35