Full Boar FBDDP-7500, Инструкция по эксплуатации

Страница: 9 / 28

9
ADDITIONAL SAFETY RULES FOR BENCH DRILLS
11. Avoid unintentional start-up: Ensure that switch is turned off when plugging the plug
into the socket.
12. Keep an eye on your work: Always keep an eye on your machine and the object
you are working on. Never use the machine when you are not concentrating or are
distracted. Never use the machine when you are under the influence of alcohol or are
taking medication.
13. Check the tool for damage:
Before using the tool, safety devices and any slightly
damaged parts must be carefully checked to ensure that they are in good working
order. Visually examine the tool’s power cable on a regular basis. All parts must be
correctly assembled and meet all the conditions required to ensure proper operation.
Unless otherwise specified in the operating instructions, any damaged safety devices
and parts must be properly repaired or replaced by a professionally recognized
workshop. Never use tools with defective On/Off switches.
14.
Your bench drill must be bolted securely to a workbench.
15.
This bench drill is intended for use in dry conditions and indoor use only.
16. Do not try to drill material too small to be securely held. Do not drill material that
does not have a flat surface unless it is clamped securely.
17. Always keep hands out of the path of the drill bit. Avoid awkward hand positions
where a sudden slip could cause your hand to move into the drill bit.
18. Do not use wire wheels, router bits, shaper cutters, circle cutters or rotary planers on this
bench drill.
19. Always hold the workpiece firmly against the table so it will not move. Use clamps
or a vice for unstable workpieces.
20. Do not exceed the rpm stated on the bit or accessory. See the instructions that come
with the accessory. Set the bench drill to a speed appropriate to the job.
21. Make sure there are no nails or foreign objects in the part of the workpiece to be drilled.
22. Do not start the bench drill while the drill bit is touching the workpiece.
23. Make sure all clamps and locks are firmly tightened before drilling.
Securely lock
the head and table support to the column, and the table to the table support before
operating your bench drill.
24. Never turn your bench drill on before clearing the table of all objects (tools, scraps of
wood etc.)
25. Let the spindle reach full speed before starting to drill.
26.
When drilling large diameter holes, clamp the workpiece firmly to the table. Otherwise,
the bit may grab and spin the workpiece at high speed.
27. Make sure the spindle has come to a complete stop before touching the workpiece.
28. Always wear safety goggles which comply to a recognised standard.
Use a face
or dust mask along with safety goggles if the drilling operation is dusty. Use ear
protectors, especially during extended periods of operation.
29. When drilling metals it is recommended to use lubricants to prolong accessories.
30.
Ensure drill bit has cooled before touching as it may be hot. Always wear gloves.