Full Boar FBDDP-7500, Инструкция по эксплуатации

Страница: 23 / 28

23
MAINTENANCE (cont.)
5.
Pry the V-belt off of the smaller drive pulley by pulling up
the belt on one side and slowly turning the
pulleys (Fig. 39).
6. The drive pulley comprises two disks that are pressed
together via a spring. If the V-belt does not exhibit
enough play to remove it, gently press the bottom half of
the drive pulley down to slacken the V-belt (Fig. 40).
7. Fit one end of the new V-belt to the variable pulley. Fit
the other end to the drive pulley by first sliding it into the
groove on one side of the drive pulley, then prying the
V-belt across the pulley into the groove on the other side
(Fig. 41). Pressing down on the bottom disc of the drive
pulley will give the V-belt additional slack.
8. Close the V-belt cover (22) and screw down using the
cover screws.
Fig. 39
Fig. 40
Fig. 41
IMPORTANT!
When replacing the V-belt, always use the correct belt type.