Fukuda Denshi LX-8000 Series, Руководство по эксплуатации

Страница: 12 / 110

x
Precautions about Waterproof
CAUTION
 To maintain the waterproof performance, replace the battery
compartment lid periodically. Otherwise, the quality of the lid will
deteriorate and cannot keep the waterproof performance. For periodic
replacement, contact your local service representative.
 When the equipment is subjected to high impact, the damage to the
enclosure or lid may degrade the waterproof performance. In such case,
contact your local service representative to check the waterproof
performance.
 The SpO
2
probes are not waterproof. Do not take a bath with the probes
attached, and keep them away from liquids.
 Do not use the transmitter when it is wet. Wipe the transmitter with a soft
cloth and dry it thoroughly before use.
Precautions about ECG Monitoring
CAUTION
 When removing electrodes from the patient, remove them carefully and
slowly. Do not apply excessive force to remove them. Otherwise, it may
damage the skin.

If any electrodes get detached from the patient after being connected to
the lead cable and patient monitor, pay attention that the metal part of
the electrode does not get in touch with any metal parts of the bed or
any conductive parts. Also, the operator should not touch any
conductive parts with bare hands. Otherwise, it may cause electric
shock to the patient and/or operator due to excessive leakage current.
 The indication for continuous use of the electrode is about one day.
 Replace the electrode if the skin contact gets loosen due to perspiration,
etc.
 When an electrode is attached to the same location for a long period,
some patients may develop skin irritation. Check the patient's skin
condition periodically and change the electrode site as required.
 For stable ECG monitoring, verify proper electrode placement, lead, and
waveform size. If not properly selected, it may cause erroneous
detection.
 There are some cases when the pacemaker pulse cannot be detected
depending on the pacemaker type, pulse voltage, pulse width, electrode
lead type (unipolar, bipolar), or electrode placement which causes the
pacemaker pulse amplitude to decrease, and disables the pacemaker
pulse detection.
 If signals similar to a pacemaker pulse are present, such as electric
blanket noise or excessive AC frequency noise, these may be
erroneously detected and displayed as a pacemaker pulse. In such
case, check the condition of the electrodes and lead cables to resolve
the cause or turn off the pacemaker detection setting on the receiving
monitor.
 If a pacemaker pulse is continuously detected due to AC frequency
interference, QRS detection will not be properly displayed.