Fukuda Denshi LX-8000 Series, Руководство по эксплуатации

Страница: 14 / 110

xii
WARNING
cross contamination. It is intended for single patient use only. For
details, refer to the operation manual of the SpO
2
sensor.
 Measuring on a limb with NIBP cuff, arterial catheter, or intracatheter
may result in incorrect measurement.
Venous congestion may cause under reading of actual oxygen
saturation. Therefore, assure proper venous outflow from monitored site.
Sensor should not be below heart level (e.g. sensor on hand of a patient
in a bed with arm dangling to the floor).
CAUTION
For the following case, accurate measurement may not be possible.
 Patient with excessive abnormal hemoglobin (COHb, MetHb)
 Patient with the pigment injected to the blood
 Patient receiving CPR treatment
 When a probe is applied to a limb with NIBP cuff, arterial catheter, or
intracatheter
 When measuring at position with venous pulse
 Patient with body motion
 Patient with small pulse
 Excessive body motion (patient’s motion)
 Excessive light (direct sunlight, fluorescent, light therapy equipment,
surgical light, infrared heat ramp, etc.)
 External colorant such as nail polish
 Abnormally low or high hemoglobin concentration
Precautions about Output Signal
WARNING
Do not use the output signal of the monitor that receives radio wave signal
from this equipment as the trigger signal for MRI, echocardiographic, or
defibrillator. It may lead to a delay of operating timing due to the delay time
of waveform transmission. A trigger signal unrelated to the heart rate may
be generated due to the interfusion of spike noise at weak electric field.
Precautions about Accessories and Optional Accessories
WARNING
Use only the specified disposable electrodes, lead cable, SpO
2
probes,
etc. Otherwise, this equipment cannot deliver its maximum performance
and may be damaged, resulting in a safety hazard.