Fujitsu MCE3064SS, Руководство по эксплуатации продукта

Страница: 90 / 181

C156-E097-01EN 4 - 9
(3) Write cache mode
The write cache mode can be set. The write cache mode can also be enabled or disabled by the
MODE SELECT command.
When the write cache mode is enabled, the cache control page is added to the code page of the
mode parameter even if the SCSI-1 is set. Table 4.3 shows the settings of the write cache mode.
Table 4.3 Write cache mode setting
Write cache mode SW1-05
Write cache is enabled at executing the
WRITE/WRITE AND VERIFY command. ON
Write cache is disabled at executing the
WRITE/WRITE AND VERIFY command OFF (*1)
*1 Setting when delivered
(4) Device type mode
Table 4.4 shows Device type mode setting.
Table 4.4 Device type mode setting
Device type mode SW1-06
‘0x07’ optical memory drive ON (*1)
‘0x00’ direct access drive OFF
*1 Setting when delivered
(5) Spindle automatic stop mode
Normally, with the cartridge loaded, the spindle rotation is maintained until the spindle is
instructed to stop by the START/STOP UNIT command. The spindle auto stop function
automatically stops the spindle after the command has not been issued from the host for about 30
minutes (default value). When the command is issued from the host with the spindle
automatically stopped, the optical disk derive turns the spindle again and performs processing in
the same manner as in a ready state without posting a not ready state.
The access supervision time from the host is about 33 minutes as the default. However, it can be
changed by the MODE SELECT command.
The spindle auto stop mode can also be changed by the MODE SELECT command.
Table 4.5 shows spindle auto stop mode setting.