Fujitsu MCE3064SS, Руководство по эксплуатации продукта

Страница: 8 / 181

C156-E097-01EN vii
Important Alert Items
Important Alert Messages
The important alert messages in this manual are as follows:
A hazarous situation could result in minor or moderate personal injury if the
user does not perform the procedure correctly. This alert signal also
indicates that damages to the produt or other property,
may occur if the user
does not perform the procedure correctly.
Task Alert message Page
Operation
Low temperature burns:
The surface temperatures of some ICs on the printed circuit board
unit in the optical disk drive exceed 55°C while operating. Be
careful of low tenperature burns.
3-1
Installation
Loss of data
When the verify function is invalid, the write data quality is not
guaranteed. This mode should not be used for storing important
data. When using the mode for storing important data, a
preventive system measure such as file duplication is required.
3-26
1) Shock or vibration applied to the drive that exceeds the values
defined in the standard damage the drive. Use care when
unpacking.
2) Do not leave the drive in dirty or contaminated environments.
3) Since static discharge may destroy the CMOS devices in the
drive, pay attention to the following points after unpacking:
• Use an antistatic mat and wrist strap when handling the
drive.
• Hold the mounting frame when handling the drive. Do
not touch the PCA except when setting the switches.
4) When handling the drive, hold both sides of the mounting
frame. When touching other than both sides of the mounting
frame, avoid putting force.
5) Do not forcibly push up the end of the header pin of the
printed circuit board unit when handling or setting the drive.
4-1
4-2