Fujitsu AOTG30KMTC, Руководство по обслуживанию

Страница: 80 / 199

2-28. E: 84. Current sensor error (Outdoor unit)
Indicator
Indoor unit
Operation indicator 8 time flash
Timer indicator 4 time flash
Economy indicator Continuous flash
Error code E: 84
outdoor unit
Refer to “Error code table (Outdoor unit: for 34 model
only)” on page 1
Detective actuator Outdoor unit main PCB
When input current sensor has detected 0 A, while
inverter compressor is operating at higher than 56 rps
(for 30 model) or 50 rps (for 34 model), after 1 minute
upon starting the compressor. (Except during the defrost
operation)
Forecast of cause
Defective connection of electric components
External cause
Main PCB failure
Check point 1. Reset power supply and operate
If no, go to "Check point 1-2" .
Does error indication show again?
↓
Check point 2. Check connections of outdoor
unit electrical components
Upon correcting the removed connector or mis-
wiring, reset the power. • Check if the terminal connection is loose.
• Check if connector is removed.
• Check erroneous connection.
• Check if cable is open.
↓
Check point 3. Replace main PCB
If Check point 1, 2 do not improve the symptom,
change main PCB.
↓
End
Check point 1-2. Check external cause at Indoor and Outdoor (Voltage drop or Noise)
• Instant drop: Check if there is a large load electric apparatus in the same circuit.
• Momentary power failure: Check if there is a defective contact or leak current in the power sup-
ply circuit.
• Noise: Check if there is any equipment causing harmonic wave near electric line. (Neon bulb or
electric equipment that may cause harmonic wave)
Check the complete insulation of grounding.
↓
End
2-28. E: 84. Current sensor error (Outdoor unit)
- (03-42) -
2. Troubleshooting with error code
TROUBLESHOOTING TROUBLESHOOTING