Fujitsu Siemens Computers STYLISTIC ST50XX, Руководство пользователя

Страница: 26 / 79

Using the Tablet PC
18 A26391-K145-Z120-1-7619, edition 3
Enabling Suspend mode
The Tablet PC allows you to suspend the system operation without closing programs or exiting the
operating system. Use this feature to conserve battery power when a system shutdown is not
practical or when the battery needs to be changed.
i
If you have set your system to turn Shut down from the Power Options utility in the Control
Panel, the following procedure will not be possible, since pressing the button shuts the
system down rather than suspending it. To change the power options, go to
Start - Control
Panel - Power Options .
To suspend system operation:
► Press the On/Resume/Suspend button, or carry out the Standby command from your
operating system or power management program.
If your system is configured to suspend operation using Hibernate mode, a message is displayed
while data is saved to your hard disk.
!
If you are replacing the battery, wait until system operation is suspended and the power
indicator is blinking before you remove the battery. Failure to do so could result in loss of
your unsaved data.
(Note that if the
Resume On LAN function is enabled in the BIOS Setup , you should not
remove the battery unless the system is shut down. When Resume ON LAN is enabled,
the buffer battery is disabled in order to optimise battery life.)
The power indicator either flashes (Suspend-to-RAM) or is not displayed (Hibernate) when
system operation is suspended, depending on how your system is configured. At this
point, programs that were running are stopped, active data is saved, and the system
enters one of two different low-power modes, or suspend modes, as explained in the
following paragraphs
Observe the power indicator in the status display to determine which suspend mode your system is
using.
– Flashing: Suspend-to-RAM mode
In this mode, the data is retained in RAM memory by keeping power applied to the RAM
memory while most of the other system components are switched off. The Battery Gauge
icon indicates the battery charge level.
– Is not displayed (dark): Hibernate mode
In this mode, active data is stored on the hard disk drive. Power draw is reduced to the
same level used in OFF mode.
When the system is in Hibernate mode, the battery gauge icon is not visible. In this
mode, there is no danger of losing data if battery power is lost.