DryLam
A Trademark of Martin Yale Industries
251 Wedcor Avenue, Wabash, IN 46992
Brian Jennett- Tech-Line & Service Advisor/Manager
Phone: (260-569-7231)
ALM3230 Customer Instruction Manual.docx
Page 64 of 68
The surface of Feeding Rollers is
not clean.
Remove paper from the feed tray. Open Feeder Cover.
Wipe off the gray Feed Rollers (particularly the first
roller) with a soft cloth. Press RESET button to clear
error and try again.
Paper is stuck between feeding
section and lamination section.
Open Feeder Cover. Remove all the stuck paper. Press
RESET button to clear error. CAUTION: The lamination
rollers get very hot.
●”PAPER JAM”
Do not confuse with “PAPER
STUCK”. This is a different error.
Film/paper is stuck at Cutter
section or Trimmer section.
Follow the instructions for the problem. Laminated
sheet is not discharged.
Paper is longer than 20” (see
Use shorter paper or, place ALM3230 into “LONG
MODE” to laminate longer sheets.
Paper is within spec length but, a
second sheet of paper has been
pulled in underneath the first
sheet of paper that the error
occurred on. The second sheet of
paper is blocking the feeder
sensor.
Reset the stack of paper on the feeder tray. Press RESET
to clear the error and start again. Make a small
downward adjustment to the Paper Feed Resist Roller
Pressure adjust lever (see
ROLLER PRESSURE ADJUSTMENT (MECHANICAL)
Double cutting, too?
Check Cutter sensor- the red number should read ~330-
400 when the laminator is “unthreaded” and the cutter
unit is installed properly. Should read about 265-275
with the Cutter Unit removed. Threshold (green
number) should be about 48. If cutter installed value is
lower than cutter removed value, check film guides on
Cutter Unit. Contact DryLam’s Tech-Line for details on
these service issues.
●”DISCHARGE ERROR”
Film and/or paper is hanging
from the discharge while the
START button is being pressed.
Before pressing START use the CUT button and pull
waste from the discharge. The error may go away on its
own, or press RESET to clear the error. Then press START
and try again.
Laminated film has a curl and has
either curled UP into the area
between the cutter and trimmer
units. Or, DOWN into the waste
collection box.
[1] Press RESET button. [2] Cut the upper and lower film
between heat rollers and film guide bar. Press Manual
Feed Switch to BACKWARD. Remove (unthread) the film
and any paper that may be in the lamination section.
Review “Manual Mode’, above, to identify and adjust
the film curl.
If this error occurs repeatedly contact DryLam’s Tech-
Line for assistance.