DryLam
A Trademark of Martin Yale Industries
251 Wedcor Avenue, Wabash, IN 46992
Brian Jennett- Tech-Line & Service Advisor/Manager
Phone: (260-569-7231)
ALM3230 Customer Instruction Manual.docx
Page 37 of 68
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
Minimizing the curl may avoid problems as shown below. If
film is allowed to curl it will curl up or down into interior
areas of the machine. This will results in errors and possible
damage to the machine.
The proper tension set with new film rolls will likely be too great as film rolls get smaller with use. Too much
tension will result in noise, poor performance and increased wear on the heat rollers. Also, as film rolls reduce
in diameter due to use, curling may begin. If curling is allowed to continue film may curl back up inside the
ALM3230 and causes jams and wraparounds. If so, re-adjusting the tension controllers may be necessary.
Other results of poor tension controller settings:
A)
The corner of the laminated film is folded.
B)
Lamination scrap comes out with laminated film.
C) Errors appear on the display.
In these cases remove the jammed film.
Follow the trouble shooting procedures of the instruction manual.