FUSION SPLICER 90S Rev5
5
WARNINGS!
Use only proper power source.
• Proper AC power source is AC100-240V, 50-60Hz. Check the AC power
source before use. Proper DC power source is DC10-12V. Improper AC
or DC power source may cause fuming, electric shock or equipment
damage and may result in personal injury, death or fire.
• AC generators commonly produce abnormally high AC output voltage or
irregular frequencies. Measure the output AC voltage with a circuit
tester before connecting the AC power cord. Such abnormally high
voltage or frequency from a generator may cause fuming, electric shock
or equipment damage and may result in personal injury, death or fire.
Make sure the generator is regularly checked and serviced.
•When using an AC generator with AC output voltage of AC220-240V
especially, Fujikura Ltd. recommends the following measures to correct
the condition.
1.
Connect a step-down transformer between the generator and the AC
adapter in order to lower the AC voltage from AC220-240V to AC100-
120V.
2.
Or, use an AC generator with AC output voltage of AC100V.
3.
Or, use an AC generator that has an inverter circuit to stabilize the
output.
Do not modify, abuse, heat or excessively pull on the supplied AC cord.
The use of a damaged cord may cause fuming, electric shock or
equipment damage and may result in personal injury, death or fire.
The fusion splicer uses a three-prong (core) AC cord that contains an
earthed ground safety mechanism. The fusion splicer MUST be
Grounded. Use only the supplied three-prong (core) AC power cord.
NEVER use a two-prong (core) power cord, extension cable or plug.
Connect AC power cord properly to the fusion splicer (inlet) and wall
socket (outlet). When inserting the AC plug, make sure there is no dust or
dirt on the terminals. Engage by pressing the female plug into the fusion
splicer (inlet) and the male plug into the wall socket (outlet) until both
plugs are fully seated. Incomplete engagement may cause fuming,
electric shock or equipment damage and may result in personal injury,
death or fire.
Do not short-circuit the terminals of AC adapter and optional battery.
Excessive electrical current may cause personal injury due to fumes,
electric shock and equipment damage.
WARNINGS!
Do not touch the fusion splicer, AC power cord and AC plugs with wet
hands. This may result in electric shock.
Do not operate fusion splicer near hot objects, in hot temperature
environments, in dusty / humid atmospheres or when water-
condensation is present on the fusion splicer. This may result in
electric shock, fusion splicer malfunction or poor splicing performance.
When using optional battery, follow the instructions below.
Failure to follow these may result in explosion or personal injury.
• Do not charge battery with other methods than instructed.
• Do not discard battery into an incinerator or fire.
• Do not charge or discharge battery near a flame or under direct
sunlight.
• Do not excessively shake or jar the battery.
• If battery leaks of liquid residue, be careful handling the battery so
the liquid does not get in skin or eye contact. If it reaches contact,
immediately wash skin or eyes thoroughly and see the doctor.
Dispose of the battery and call the service center for replacement.
• Do not stack battery on top of AC adapter while charging.
• If charge did not complete in five hours or the "CHARGE" LED
does not turn ON, immediately stop charging and call the service
center for repair.
When transporting the carrying case using the shoulder belt, check the
belt and hooks for damage before use. Carrying the case with a
damaged shoulder belt may cause the belt to break or come off and
result in personal injury or equipment damage.