DC IN 5V
Socket
17
1
LOADING THE SmartMedia
™
16
SELECTING THE POWER SUPPLY
Load the battery and connect the AC power
adapter. After approximately 3 seconds, the
indicator lamp turns orange and charging
begins. When charging ends, the indicator lamp
goes off.
Check that the camera is switched off. Open the
terminal cover and insert the AC power adapter
connector plug into the “DC IN 5V” socket. Then
plug the AC power adapter into the power outlet.
To shoot or play back images without depleting
the battery charge, use the special AC Power
Adapter AC-5V/AC-5VH.
●
!
The socket-outlet shall installed near the equipment
and shall be easily accessible.
●
!
The shapes of the plug and socket-outlet depends
on the country of use.
●
!
Using AC power adapters other than the AC-5V/AC-
5VH could damage the camera.
●
!
See P.116 for more information on the AC power
adapter.
●
!
A fully discharged battery takes about 5 hours to
recharge.
●
!
An almost fully charged battery will not charge. This
is normal and does not indicate a fault.
●
!
If you switch the camera on while the battery is
charging, the charging will stop.
●
!
The battery will not charge if the AC power adapter
connector is not correctly plugged into the camera.
●
!
Charging times can be shortened by using the
optional Battery Charger BC-80 (
Connecting the AC Power Adapter
Charging the Battery
●
!
Images cannot be recorded or erased if a write-
protect sticker is affixed to the SmartMedia.
●
!
Operation of this camera is only guaranteed when it
is used with FUJIFILM SmartMedia.
●
!
Some 3.3V SmartMedia are labelled as “3V” cards.
●
!
See P.118 for more information on SmartMedia.
➀
Check that the camera is switched off and
open the slot cover.
➁
Push the SmartMedia firmly into the
SmartMedia slot as far as it will go.
➂
Close the slot cover.
●
!
If you open the slot cover while the camera is
switched on, the camera is automatically switched
off to protect the SmartMedia.
●
!
The SmartMedia will not slide fully into the slot if it is
inserted facing the wrong way. Be careful not to
apply undue force to the SmartMedia.
SmartMedia™ (sold separately)
■
Only use 3.3V SmartMedia
MG-4S ( 4MB), MG-16SW (16MB, ID)
MG-8S ( 8MB), MG-32SW (32MB, ID)
MG-16S (16MB), MG-64SW (64MB, ID)
MG-32S (32MB)
MG-64S (64MB)
●
➀
●
➁
●
➂
