38
INZ-TN2ZRE-E
<Gas flow time> setting
(1) Press the
ENT
key in a state where the cur-
sor is placed preceding “Flow Time,” and
the flow time setting screen appears.
(2) Move the cursor to the gas you want to
change by pressing the or the key,
and then press the
ENT
key.
(3) The highlighted value can be changed.
Change the value by pressing the or
the key, and then move the cursor to
the right by pressing the key.
(4) After changing the value, press the
ENT
key.
(5) Press the
ESC
key to return to the auto-
matic calibration setting screen.
Note) Only the Chs used are displayed on
this screen. The Ex. time is the out-
put signal hold extension time after
the completion of calibration. It is
valid only when the hold setting is
set to “ON.” The Ex. time set here
is also the hold extension time at the
time of manual calibration.
( )
ENT
