24
EN
j - If the option selected in the previous step was “
No
”, it
is necessary to access the “
CAN Communication
” menu
within “
Sensors and Calibration
” and click on the option
“
Enable inputs
”.
Configure Hall and VR sensors for frequency input
Hall: Use the red wire for the signal and the white wire should
be disconnected. In this case, it is necessary to feed the sensor
with positive and negative
VR: Use the white wire for signal reference and the red wire
for the signal
Troubleshooting
- ECU is not reading data from FT Input Expander
•
Make sure the FT Input Expander has the correct map (See item 7 of this manual).
•
Make sure to send the map to the FT Input Expander (See item 7 of this manual).
•
Make sure that the map of the ECU has the inputs enabled via the CAN Network (See item 7 of this manual).
•
- FT Input Expander is not communicating with FTManager
•
Check the electrical connection of the module.
•
Check the connection of the CAN network connectors.
