Frymaster FQE60U FilterQuick easyTouch, Инструкция по установке, эксплуатации и обслуживанию

Страница: 37 / 42

6-9
Code ERROR MESSAGE EXPLANATION
E39 CHANGE FILTER PAD 25-hour timer has expired or dirty filter logic
has activated.
E41 OIL IN PAN ERROR The system detects that oil may be present in
the filter pan.
E42 CLOGGED DRAIN (Gas) Vat did not empty during filtration
E43 OIL SENSOR FAILURE - CALL SERVICE Oil level sensor may have failed.
E44 RECOVERY FAULT
Recovery time exceeded maximum time limit.
E45 RECOVERY FAULT – CALL SERVICE Recovery time exceeded maximum time limit
for two or more cycles.
E46 SYSTEM INTERFACE BOARD 1 MISSING - CALL
SERVICE SIB board 1 connection lost or board failure.
E51 DUPLICATE BOARD ID - CALL SERVICE Two or more controllers have the same
location ID.
E52 USER INTERFACE CONTROLLER ERROR - CALL
SERVICE The controller has an unknown error.
E53 CAN BUS ERROR - CALL SERVICE Communications are lost between boards.
E54 USB ERROR USB connection lost during an update.
E55 SYSTEM INTERFACE BOARD 2 MISSING - CALL
SERVICE SIB board 2 connection lost or board failure.
E61 MISCONFIGURED ENERGY TYPE The fryer is configured for the incorrect
energy type.
E62 VAT NOT HEATING – CHECK ENERGY SOURCE –
XXXF OR XXXC The vat is not heating properly.
E63 RATE OF RISE Rate of rise error occurred during a recovery
test.
E64 FILTRATION INTERFACE BOARD FAILURE -
FILTRATION AND TOP OFF DISABLED - CALL
SERVICE Filtration Interface Board connections lost or
board failure.
E65 CLEAN OIB SENSOR – XXX F OR XXX C - CALL
SERVICE Gas -The oil is back sensor does not detect oil.
Clean oil sensor.
E66 DRAIN VALVE OPEN – XXXF OR XXXC Drain valve is opened during cooking.
E67 SYSTEM INTERFACE BOARD NOT CONFIGURED -
CALL SERVICE Controller is turned on when the SIB board is
not configured.
E68 OIB FUSE TRIPPED – CALL SERVICE The VIB board OIB fuse has tripped and didn’t
reset.
E69 RECIPES NOT AVAILABLE – CALL SERVICE The controller has not been programmed
with product recipes. Replace controller with
factory programmed controller.
E70 OQS TEMP HIGH Oil temperature is too high for a valid OQS
reading. Filter at a temperature between
300ºF (149ºC) and 375ºF (191ºC).
E71 OQS TEMP LOW Oil temperature is too low for a valid OQS
reading. Filter at a temperature between
300ºF (149ºC) and 375ºF (191ºC).
E72 TPM RANGE LOW The TPM is too low for a valid OQS reading.
This may also be seen with fresh new oil. The
incorrect oil type may be selected in the setup