Frymaster FQE60U FilterQuick easyTouch, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 42

3–3
3.2 Operation
This fryer is equipped with FilterQuick ™ FQ4000 controller(s) (illustrated below). Refer to the FilterQuick
FQ4000
™
Controller Operation Manual for programming and operating procedures and for operating
instructions for the built-in filtration system.
FILTERQUICK ™ FQ4000 CONTROLLER
Refer to Chapter 5 of this manual for operating instructions for the built-in filtration system.
3.3 Manual Top-Off, Automatic Top-Off and JIB/Oil Saddle Refill
The fryer can be configured for either
manual top off or for both manual and
automatic depending on the hardware.
When a vat is low, press the manual top off
(oil drop) button at the bottom of the
screen (see Figure 3) to top off the vat. The
controller displays PUSH BUTTON TOP OFF?
Press the YES (√) bu tton. START FILLING? is
displayed. Press and hold the button to
start filling. Release the button when the oil
is at the top oil level line. Press the NO (X)
button to exit. If the unit has optional auto
top off, the frypot oil levels are continually
checked and topped off as necessary from a
reservoir in the cabinet or the saddle oil
reservoir attached to the cabinet. The
reservoir holds a 35-pound box of oil. In a
typical operation this will last approximately
two days before changing.
Components of the system are annotated at
the right and below (see Figures 1 and 2).
NOTE: The top off system is intended to
top off the frypots, not fill them. The
frypots will require manual filling upon
startup and after disposal unless a bulk
fresh system is used.
Special Cap: Has plumbing
attached to draw oil from the
reservoir to the fryer vats.
Jug In Box (JIB):
The JIB is the
reservoir for the oil.
JIB (Jug In Box) Low
Reset Switch: Resets
the ATO system after
oil change.
Figure 1