Frymaster FQE60U FilterQuick easyTouch, Инструкция по установке, эксплуатации и обслуживанию

Страница: 33 / 42

6-5
Problem Probable Causes Corrective Action
Filter Pump runs, but
oil return is very
slow.
A. Clogged filter pad/paper.
B. Improperly installed or prepared
filter pan components.
C. Pre-filter screen may be clogged or
not fully tightened.
A. Ensure the filter is not clogged.
If so replace the filter.
B. Remove the oil from the filter
pan and replace the filter
pad/paper, ensuring that the
filter screen is in place
under
the pad/paper.
Verify, if using a pad, that the
rough side is facing up.
Verify that O-rings are present
and in good condition on filter
pan connection fitting.
C. Clean pre-filter (see section 4.5.4)
and ensure it is tightened with
the attached wrench.
6.2.3.1 Incomplete Filtration
Should the auto filtration procedure fail an error message is generated. Follow the instructions on the
screen to return the oil and clear the error.
DISPLAY ACTION
IS VAT FULL?
1. Press the √ (check) button if the vat is full to continue. The
controller returns to idle cook mode or . Press X if vat is
not filled completely.
FILLING IN PROGRESS 2. No action required as the pump runs.
IS VAT FULL?
3. Press the √ (check) button if the vat is full to continue. The
controller returns to idle cook mode or . Press X if vat is
not filled completely.
FILLING IN PROGRESS 4. No action required as the pump runs.
IS VAT FULL?
5. Press the √ (check) button if the vat is full to continue. The
controller returns to idle cook mode or . Press X if vat is
not filled completely. If this is the sixth consecutive
sequence of incomplete filtration skip to step 10.
CHANGE FILTER PAPER?
6. Press the √ (check) button to continue. Pressing X advances
to .
REMOVE PAN 7. Remove the filter pan.
CHANGE FILTER PAPER
8. Change the filter paper/pad and ensure the filter pan has
been pulled forward, out of the cabinet for at least 30
seconds. Once the pan has been out for 30 seconds the
controller returns to idle cook mode. Ensure the pan is dry
and assembled correctly. Push the filter pan back into the
fryer. Ensure “P” is not displayed on the controller.
IS VAT FULL?
9. Press the √ (check) button if the vat is full to continue. The
controller returns to idle cook mode. Press X if vat is not full
and the controller advances to
.