Frymaster FQE60U FilterQuick easyTouch, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 42

3–5
3.3.2.1 Routine Oil Changes (JIB only)
1. Open the cabinet and slide the JIB from
the cabinet (see Figure 5).
Figure 5
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 6).
Figure 6
3. With the jug upright remove the cap and
foil seal (see Figure 7).
Figure 7
4. Put the tube in the new full container (see Figure 8).
Figure 8
5. Slide the JIB onto the shelf inside the fryer cabinet (as
seen in Figure 5).
6. Press and hold the orange JIB reset switch five (5)
seconds to reset the top off system (see Figure 9).
Figure 9
3.3.2.2 Routine Oil Changes (Saddle Oil Reservoir only)
1. Remove saddle oil reservoir lid.
2. Fill the oil saddle with oil.
3. Replace saddle oil reservoir lid.
4. Press and hold the orange ATO reset switch five (5) seconds to reset the top off system (see Figure
9).
The system is now ready for operation. As the fryer heats to preprogrammed temperatures, the system
will energize and then slowly add oil to the frypot as needed, until the oil reaches an optimal level.
3.3.3 Bulk Oil Systems
Instructions for installing and using bulk oil systems are found in Appendix A located at the rear
of this manual.
WARNING:
Do not add HOT or USED oil
to a JIB or Saddle Oil
Reservoir.