Frymaster FQE60U FilterQuick easyTouch, Инструкция по установке, эксплуатации и обслуживанию

Страница: 25 / 42

5–2
If you notice that the system is pumping slowly or not at all, verify that the filter pan screen is on the
bottom of the filter pan, with the paper on top of the screen. Verify that the two O-ring(s) on the fitting
at the right front of the filter pan are present and in good condition.
5.2.4 Clean Filter Pan, Detachable Parts and Accessories
Carbonized oil will accumulate on the filter pan and detachable parts and accessories such as baskets,
sediment trays, or fish plates.
Wipe the filter pan and all detachable parts and accessories with a clean cloth dampened with a
detergent solution (or the parts can be run through a dishwasher). Rinse and thoroughly dry each part.
DO NOT use steel wool or abrasive pads to clean these parts. The scratches that result from such
scrubbing make subsequent cleanings more difficult.
5.2.5 Clean around AIF and ATO sensors – Daily
1.
Clean the sediment from around the AIF and ATO sensors during clean
and filter when the oil is drained from the frypot.
2. Use a screwdriver or other similar object which allows access around
the probe (see Figure 1). Use caution to ensure that the probe is not
damaged.
3. Return the oil once the clean and filter is complete.
5.2.6 Clean Basket Lift Rods - Daily
On fryers equipped with basket lifts, wipe down the rods with dry, clean
cloth to remove accumulations of oil and dust.
5.3
WEEKLY CHECKS AND SERVICE
5.3.1 Clean Behind Fryers - Weekly
Clean behind fryers in accordance with store procedures. Shut the fryer off and disconnect power.
5.4
MONTHLY CHECKS AND SERVICE
5.4.1 Drain, Clean Frypot and Heating Elements
DANGER
Never operate the appliance with an empty frypot. The frypot must be filled to the fill line with
water or oil before energizing the elements. Failure to do so will result in irreparable damage to
the elements and may cause a fire.
After the fryer has been in use for a period of time, a hard film of caramelized oil will form on the inside
of the frypot. This deposit must be periodically removed to maintain your fryer’s efficiency.
See the Clean and Filter procedure instructions in the FilterQuick
™
controller manual to clean the frypot .
Figure 1