frost-trol LOMOND PI0C008640FDPD17, Руководство по установке и обслуживанию

Страница: 24 / 38

INSTALLATION AND MAINTENANCE MANUAL
TRANSLATION OF THE
ORIGINAL DOCUMENT
For additional copies visit:
www.frost‐trol.com
LOMOND
SOLID LINES
D007918 Versión: 3 -23-
Category Parameters Message Icon
Probe parameters / ‘Pro’
Control parameters R ‘Ctl’
Compressor parameters C ‘CMP’
Defrost parameters D ‘dEF’
Alarm parameters A ‘ALM’
Fan parameters F ‘Fan’
Configuration parameters H configuration ‘CnF’
HACCP parameters H HACCP ‘HcP’
RTC parameters rtc ‘rtc’
Tabla 8. Icônes.
For both types of access (type “F” and type “C”) there is a timeout (no button on the
keypad pressed for 1 min), the procedure is ended without saving the parameter.
3.5. ALARMS WITH MANUAL RESET
The alarms with manual reset can be reset by pressing the PRG and UP/CC for more
than 3 s.
3.6. MANUAL DEFROST
As well as the automatic defrost function, a manual defrost can be enabled, if the
temperature conditions allow, by pressing the DOWN button for more than 5 s.
3.7. PRODUCT LOADING AND PRESERVATION
Please, don’t load product before three hours since starting up the cabinet. Anycase,
always check the working temperature before loading products inside.
Loaded product should be at least at its range temperature or better. The
cabinet is not able to decrease product temperature; cabinet only is able
to preserve temperature.
Please note the following points when loading the cabinet:
‐
Do not exceed the maximum load limit;
‐
Do not obstruct the aspiration grid or air discharge conduits;
‐
Do not load products that have higher temperatures than the cabinet’s
operating temperature;