INSTALLATION AND MAINTENANCE MANUAL
TRANSLATION OF THE
ORIGINAL DOCUMENT
For additional copies visit:
www.frost‐trol.com
LOMOND
SOLID LINES
D007918
Versión:
3
-20-
2.5.
ELECTRICAL CONNECTION
The assembly, installation and connection of these cabinets must be carried
out by a certified technician.
Before obtaining access to terminals, all supply circuits must be
disconnected.
Consult the circuit diagrams that are supplied with each cabinet when carrying out
the electrical connections and observe all of your country’s safety regulations in full.
For the electrical connection it is mandatory to incorporate a switch
disconnector in accordance with installation regulation. This switch has
to be directly connected to supply terminals and has to be able to
provide full disconnection in all poles under overvoltage Category III
conditions.
Before plugging into the mains, check that the supply voltage is the same as the
voltage indicated on the nameplate. The electricity supply should be adequate for
maximum consumption.
The power cords must be properly spread out, safe from shocks and far
from liquids, water and heat sources, and in perfect condition. The use
of adaptor plugs is forbidden.
If the power cord is damaged, it must be replaced by the manufacturer
in order to avoid a hazard.
Technical cabinet data are showed in the nameplate (see Chapter 5).
Electric diagrams are in the electric box inside a plastic package.
Earthing is mandatory according to current legislation, as is providing
protection against power surges, short circuits and indirect contacts.
2.6.
CLEANING
Before the first use, it’s mandatory to clean the unit thoroughly, both inside and out,
with non-abrasive detergents and rinse well with water. Dry the inside with a cloth
so that no water remains inside the unit (see Chapter 4).
Содержание LOMOND PI0C008640FDPD17
Страница 4: ......
