frost-trol LOMOND PI0C008640FDPD17, Руководство по установке и обслуживанию

Страница: 23 / 38

INSTALLATION AND MAINTENANCE MANUAL
TRANSLATION OF THE
ORIGINAL DOCUMENT
For additional copies visit:
www.frost‐trol.com
LOMOND
SOLID LINES
D007918 Versión: 3 -22-
3.3. HOW TO ACCESS AND SET PARAMETERS
 type “F” (FREQUENT, not protected by password)
 type “C” (CONFIGURATION, password protected)
Step Action Effect Meaning
1
Press PRG for 3
seconds After 3 seconds the display will show the 1st
parameter, “0” (Password)
Access to type “F”
parameters is
direct without
password
2
Press UP/CC or
DOWN/DEF The value on the display will increase or
decrease.
Enter the password
“22” to access the type
“C” parameters or
whatever
different value for the
type “F” parameters.
3 Press SET The display will show “St” (Setpoint)
This is the current
value of the Setpoint
4
Press UP/CC or
DOWN/DEF
If the password set is 22 the display will
scroll the list of type “C” parameters
(CONFIGURATION) otherwise the list of
type “F” parameters (FREQUENT)
Set the desired value
5 Press SET The display will show the parameter name
This is the current
value of the
parameter
6
Press UP/CC or
DOWN/DEF The value on the display will increase or
decrease
Set the desired value
7 Press SET
The display will show the parameter name
again
IMPORTANT:
parameters not
yet saved
8
Repeat steps 2, 3, 4
& 5 for all
parameters required
9
Press PRG for 5
seconds The controller will display the temperature
read by the probes again
IMPORTANT: only now
have all the
parameters been
updated
Tabla 6. How to access and set parameters.
3.4. ACCESSING THE PARAMETERS BY SELECTING
CATEGORY
Step Action Effect Meaning
1 Press PRG
The display will show the name of the
functional block that the parameter
belongs to.
Example “CMP” for the
compressor
parameters, “dEF" for
defrost parameters.
2
Press UP/CC ou
DOWN/DEF The display will shown the name of the
other funcional blocks. Example “Fan” for the
fan parametres.
3 Press SET
The display will show the name of the first
parameter in the functional block selected.
Example “F0” for ‘Fan’.
Tabla 7.Accessing the parameters by selecting category.