103
EN
no | Prg
Cause:
No preconfigured program has been selected
Remedy:
Select a configured program
no | IGn
Cause:
"Ignition time out" function is active; no current started flowing before the
length of wire specified in the set-up menu had been fed. The power source
safety cut-out has tripped.
Remedy:
Shorten the wire end; press the torch trigger again; clean the surface of the
workpiece; if necessary, increase the wire length until the safety cut-out trips
in "Set-up menu: Level 2".
EPG | 17
Cause:
The welding program selected is invalid
Remedy:
Select valid welding program
EPG | 29
Cause:
The required wire-feed unit is not available for the selected characteristic
Remedy:
Connect correct wire-feed unit, check plug connections for the hosepack
EPG | 35
Cause:
Measurement of the welding circuit resistance "r" failed
Remedy:
Check grounding cable, current cable or hosepack and replace if necessary,
recalculate welding circuit resistance "r"
no | GAS
Cause:
The Gas watchdog option has detected that there is no gas pressure
Remedy:
Connect a new gas cylinder or open the gas cylinder valve/pressure regulator,
restart "Gas watchdog" option, reset "no | GAS" error message by pressing
any button.
Содержание VR 5000 noSpool
