Fronius IG 2000, Руководство по эксплуатации

Страница: 46 / 116

44
Inserting and
connecting op-
tion cards When adding option cards to the inverter, please follow all inverter safety instructions and
information before opening the inverter.
Switch the AC and DC disconnect on the inverter to the OFF position
Open connection area
* Insert the Com Card in the left-most slot named "ENS"
** Insert any of the following cards in option slot 1 or 2:
Datalogger Card, Personal Display Card, Interface Card easy, Sensor Card
Insert option card (2) into a free slot
Tighten option card (2) with fastening screw (1)
Remove knockouts (3) for data communication cables
Insert a 1/2 or 3/4 in. conduit fitting in the knockout (3) labeled "DatCom" and fasten it
1
2
CAUTION! Danger of short circuit by loose metal parts from knockouts. Loose
metal parts in the inverter may cause short circuits when the inverter is powered
up. When removing knockouts, make sure that
-
no loose metal parts fall into the inverter,
- any metal pieces that do fall into the inverter are removed immediately.
NOTE! Use only water tight conduit fittings and conduits. Conduit fittings and con-
duits are not part of the scope of supply for the inverter.
**
(3)
(2)
*
(1)
(3)
3
4
5
6