FS3.2780-Manual-34.111XXXXXXXXX.V01-EN03.doc
For further updates, see our website www.fromm-stretch.com and Login!
It is forbidden t
o duplicate this manual or parts thereof or any other form without the author’s authorisation © 2018
20
INSTALLATION INSTRUCTIONS
CAUTION!
All operations indicated can be performed exclusively under the supervision of the manufacturer’s
trained personnel or of its agents!
Refer to the diagram in the
SAFETY DEVICES
paragraph for the numbers of the indicated positions.
General guidelines
Always check that the minimum conditions for placement and operation of the machine are met,
especially: environmental conditions (suitable floor), temperature, humidity, lighting and suitability of
the area chosen.
Installation is strictly forbidden in environments subject to a risk of flooding, explosion or fire.
The area required for installation of the wrapping machine corresponds to the dimensions of the
machine and the space for its installation and operation.
The machine must be installed by trained personnel, coordinated directly with the authorised
Technical Service, in total compliance with the following instructions, as well as with the health and
safety laws in force.
As a precaution, always check for any damage that may have occurred during transport or during the
handling operations.
If necessary, contact the Manufacturer directly.
Temperature
For safety reasons, make sure that the machine operates at an environmental temperature in the
range of +5° / +30°C.
If different values are measured, urgently contact the Authorised Technical Service.
Work areas
It is strictly forbidden to place and/or use the machine if the environmental conditions constitute a
potential risk of explosion or flammability.
Make sure there is no concentration of dusts, gas, fumes, or dangerous particles, electrostatic fields,
excessive electromagnetic flux, or anything else that could be harmful to exposed people or to correct
operation of the machine.
Always comply with the health and safety laws in force.
The machine must be positioned on a flat, rigid, concrete surface without vibrations.
Do not improperly access the top components of the machine.
Energy sources
The customer must provide a cable suitable for the power supply voltage requested for the control
cabinet with wire diameter able to manage the total voltage requested, as indicated in the
TECHNICAL
DATA
chapter.
The wrapping machine must be connected preferably to the customer’s wall socket with a cable and
standard EEC plug, with a 16A (slow) fuse.
For information on the correct plug, refer to the
TECHNICAL DATA
chapter.
If necessary, the customer must provide a network switch that precedes the plug.
The power supply must comply with the applicable standards in terms of voltage variations allowed,
voltage fluctuation, generation of waves, reduction of high harmonics, etc.