M A D E I N I T A L Y
R
F
M
B
I
K
E
HANDLEBARS
Remove the 4 screws of the stem faceplate.
Position the handlebar according to the mark-
ings inside the clamping area. Check that the
bowden cables and tubes are not twisted or
bent and that they run regularly to the handle-
bar or brake.
Insert the stem faceplate.
Tighten the stem faceplate clamping screws
alternately and evenly until the handlebars
are lightly secured.
Make sure that the slots between the stem
cover and the stem body are parallel and
have the same width at the top and
bottom.
(05)
If necessary, loosen the clamp-
ing screws again, tightening them slightly and
evenly.
Tighten the 4 screws in an X pattern. The
optimum tightening torque is indicated on the
stem.
1
4
3
2
Tightening sequence
MAX. 5Nm
05
