140.925-IOM (APR 2019)
Page 8
XLP3 EVAPORATIVE CONDENSERS
INSTALLATION
OPTIONAL ACCESSORY INSTALLATION
Bottom Water Outlet (Optional)
1. The bottom connection seal, Figure 7, is typical for all bottom
remote sump outlets. Flange mounting hardware and gasket to
be supplied by others.
2. Bottom connection seal kit(s) ship in plastic tubs.
Offset Access Platform, Perimeter Guardrail and Ladder
1. Lift the platform by fastening the lifting device to the top
guard rail so it does not slide while lifting. Lift the platform so
that the support gussets align with the mounting brackets on
the unit. See Figure 8.
2. Fasten the platform gussets to the mounting brackets using
the supplied hardware as shown in Figure 8, Detail A.
3. Loosely fasten the lower and intermediate appropriate lad-
der brackets and diagonal braces to the factory installed ladder
brackets as shown in Figure 8, Detail B and Figure 9, Detail A.
Check your submittal for the ladder orientation ordered. Attach
the ladder to the platform and fasten the lower and intermediate
brackets to the ladder side rails as shown in Figure 8, Detail B
and Figure 9, Detail A.
4. Tighten all ladder bracket fasteners.
5. Cut the ladder to length required and fasten the ladder foot
to the landing surface (anchorage hardware provided by others).
6. Using the supplied hardware, install the perimeter guardrails
at the bracket points as shown in Figure 10, Detail A and Detail B.
7. At the point where two vertical support meet, install the
factory supplied fastener through each support as shown in
Figure 10, Detail C.
NOTICE
For platform and ladder options ordered but not listed,
refer to the customer information packet supplied on the
unit.
Figure 7 — Bottom Water Outlet
Figure 8 — Platform Installation and Air-Intake Face
(Face D) Ladder Installation
Detail A.
Platform Mounting
Detail B.
Intermediate and Lower Ladder Bracket
Platform Lifting
Locations
Platform
Gusset Support
Mounting
Brackets
Platform Mounting
Fasteners (Qty. 4)