
en / 2-12
OPERATION AND USE
3.4.1.9.2
Resuming the interrupted
program
Press the rotor key (B7).
3.4.1.10
END PROGRAM
When the program time has elapsed, the buzzer
sounds and the grill switches over to keeping
warm mode. If the set temperature for the keeping
warm process is 0, the grill automatically switches
over to the standby mode.
3.4.1.10.1 Switching off the buzzer
Press the buzzer key (B22).
3.4.1.10.2 End cooking or grilling mode
Set the cooking or grilling time to 0.
The grill switches over to keeping warm mode when
the set temperature for the keeping warm process
is higher than 0. When the set tempera-ture equals
0, the grill switches over to standby mode.
3.4.1.10.3 End active program and switch
over to standby mode
Press the START/STOP key (B6).
3.4.1.11
SETTING PROGRAM END TIME
It is possible to define an end time for the pro-
gram, which means the time at which the
products must be ready. The program determines
the starting time in accordance with the set
cooking and grilling time and the required end
time. Depending on the settings, the grill switches
over to the keeping warm or standby mode.
Select a pre-defined program. (See chapter
3.4.2.4.1 for the correct procedure.)
Keep the key for end time (B15) pressed.
Press the key UP (B19) or DOWN (B16) to
set a time later than the sum of the current
time and the program duration.
Release the end time key.
Press the START/STOP key (B6).
The selected program is first in standby mode.
The program indicator (B24) and the ON indicator
(B5) are lit. The colon between the hours and the
minutes flashes. The program starts automatically
when the difference between the programmed
end time and the sum of the current time and the
program duration is 0.
3.4,1.12
TEMPERATURE SENSOR
3.4.1.12.1 Introduction
The optional temperature sensor can be used for
measuring the core temperature of the products
to be grilled. See the table at the end of annex 1
of the general users manual that came with your
grill for the required values.
3.4.1.12.2 Measuring the product
temperature
Press the rotor key (B7) to stop the drive
engine.
The heaters and the front lamp are switched off;
the rotor stops rotating. The process time stops
counting down and the ON indicator (B5) starts
flashing.
Remove the temperature sensor from the
holder (B13).
Open the grill door.
Stick the sensor into the meat so that the core
isreachedtoguaranteeapropermeasurement.
Press the key (B21) to activate the temperature
sensor. Indicator light (B26) will light up.
As long as the sensor has not registered the
temperature of the product, you can see the
temperature on the display (B27) increase and
the indicator light (B26) lights up.
Содержание STG5
Страница 1: ...STG 5 STG7 09 2005 DIRECTIONS FOR USE en 2 1 STG5 STG7 ...
Страница 3: ......
Страница 23: ......