Fresmak 040 410 090, Руководство по обслуживанию

Страница: 11 / 36

9 10
9) Rotate the clutch spindle (4019) to its full length. To do this, position the regulator at location
5. The spindle is regulated by the degree of pressure applied on tightening the spindle to the
deposit (4004). If the turn of the handle is too tight, it
should be loosened and if the handle moves with excessive ease, it should be tightened. Once
it has been set, tighten the set screw (0215) making sure it coincides with the groove nearest
the three at the head of the main spindle.
F.- Assembly of the Spindle in the Vice
1) Once the hydraulic unit (spindle) is assembled and set, remove the fleange-regulator assem -
bly and screw the bolt (4107) in the spindle. Reassemble using the set screw (0004). Mount
the complete assembly in the body of the vice (4101) tightening the flange (4024) with its four
screws (4026-090; 4051-125)
2) To mount the second bolt, screw the spindle (4003) in its interior and mount it in the body
(4101) matching the spindle male hexagons and the deposit female hexagons until they meet.
3) Verify that the bolts are equidistant from the centre (the dowel pins serve as reference points).
This position is achieved by turning of the spindle (4003) in the bolt (4102). To do so, unloosen
the hexagon and rotate until there is a difference of 15mm (in the 090 model – 12mm).
4) Having done this, screw the piston bolt (4035) and fasten it with the set screw (0215).
5) By turning the handle, now verify that the bolts slide correctly in the vice body together with
the jaws. If this is the case, tighten the screws (4026-090; 4051-125) on the flange. This is
an important operation as it includes tightening and centring-alignment of the assembly; this
is done by following a process of tightening the screws and turning the handle to check the
smoothness of the movement of the jaws.