43
P6F104 User’s Manual
AC 97 Modem:
The option are “Enabled” or “Disabled”. When set
to “Enabled” the Software Modem codec on the AMR slot will
function. Set “Disabled” can use other type PCI/ISA modem. The
default is “Disabled”.
IDE HDD Block Mode:
The Default setting is “Enabled”. This fea-
ture enhances hard disk performance by making multi-sector trans-
fers instead of one sector per transfer. Most IDE drives, except very
early design, have the Block Mode transfer feature.
Power On Function:
There are five options “Button Only” (default),
“Password”, “Hot KEY”, “Mouse Left” and “Mouse Right”. When set
to “Button Only”, system power can be turned on by power button.
When set to “Password”, system power can be turned on by entering
password. When set to “Mouse Left/Right”, system power can be
turned on by pressing PS/2 mouse left/right key. This function works
with a standard two-button PS/2 mouse only. You have to enter “pass-
word” to activate this option.
Note: If “Password” is selected for this option, the power button
will not be able to turn on the system. If you forget the password,
then you need to clear CMOS RAM. (see section 2.2.4 for detail).
KB Power ON Password:
Enter the password.
Hot Key Power On:
When “Power On Function” set to “Hot KEY”,
system power can be turned on by pressing keyboard function key,i.e.,
<Ctrl>+<F1> through <Ctrl>+<F12>.
Onboard FDC Controller:
The default setting is “Enabled”. This
option enables the onboard floppy disk drive controller.
Onboard Serial Port 1 and Onboard Serial Port 2:
These options
are used to assign the I/O addresses for two onboard serial ports. They
can be assigned as follows:
3F8/ IRQ4, 2F8/ IRQ3
3E8/ IRQ4, 2E8/ IRQ3
Auto (default)
Disabled (Disable the onboard serial port)
Chapter 3: BIOS Configuration
