P6F104 User’s Manual
20
2.2.2 Installing System Memory
The P6F104 support 100MHz SDRAM
up to 512MB. If more than maximum size
memory are populated on the P6F104
mainboard, the portion of the memory
which exceed the boundary will be
invalidated.
The P6F104 Mainboard has two 168-pin
DIMM Sockets. 100MHz-SDRAM DIMM
is the only memory supported (no EDO).
There are no jumper settings required for
the memory size or type, which is automat-
ically detected by the BIOS. Due to the
P6F104 Mainboard high speed design, the
memory modules for the P6F104 must
meet all of the following requirement:
Install 168-pin DIMM modules in any combination as follows:
168-Pin DIMM Modules Memory Configuration
.
Note: When the VCC33SBY LED is On, do not install or unload Mem-
ory Module (Must unplug power before load/unload memory.
DRAM TYPE
SDRAM (Synchronous DRAM)
Requirements
3.3V unbuffered DIMM module
Speed grade: 66.6 MHz or faster
CAS latency: 3 or faster
BANK 0
(DIMM1)
SDRAM
8MB, 16MB, 32MB, 64MB, 128MB
BANK 1
(DIMM2)
SDRAM
8MB, 16MB, 32MB, 64MB, 128MB
Total
System Memory
SDRAM
8MB to 256MB (with 16 or 64 M-bit technology)
Max. 512MB (with 128M-bit technology)
Chapter 2:Hardware Installation
B
A
N
K
1
B
A
N
K
0
ID
E
2
ID
E
1
F
D
D
J
P
2
4
D
IM
M
1
D
IM
M
2
LED
