Free Hot Water Freedom 5002, Инструкция по установке, эксплуатации и обслуживанию

Страница: 44 / 59


Page 44
Starting the commissioning help guides you in the correct order through the basic settings
necessary for commissioning, and provides brief descriptions of each parameter in the display.
Pressing the “esc” key takes you back to the previous value so you can look at the selected setting again or
adjust it if desired. Pressing the “esc” more than once takes you back to the selection mode, thus cancelling
the commissioning help.
May only be started by a specialist during commissioning! Observe the explanations for the
individual parameters in these instructions, and check whether further settings are necessary for your
application.
8. Menu Lock - Against unintentional setting changes at critical points
Menu “8. Menu lock” can be used to secure the controller against unintentional changing of the set values.
The menu is closed by pressing “esc” or selecting “Exit menu lock”. The menus listed below remain
completely accessible despite the menu lock being activated, and can be used to make adjustments if
necessary:
1. Measurement values
2. Analysis
3. Display mode
7.2. Time & date
8. Menu lock
9. Service values
To lock the other menus, select “Menu lock on”. To enable the menus again, select “Menu lock off”.
Setting range: on, off/default setting: off
9. Service Data - For diagnosis in the event of an error
The menu “9. Service values” can be used for remote diagnosis by a specialist or the manufacturer in the
event of an error, etc.
10. Language Selection - Language selection 1. Measurements
Menu “10. Language” can be used to select the language for the menu guidance. This is queried
automatically during initial commissioning. The choice of languages may differ, however depending on the
device design. Language selection is not available in every device design!