Free Hot Water Freedom 5002, Инструкция по установке, эксплуатации и обслуживанию

Страница: 40 / 59


Page 40
Solar Controller Installation
Install the controller only in dry areas and under the ambient conditions.
Carry out the following steps 1-8.
1. Unscrew cover screw completely
2. Carefully pull upper part of housing from lower part.
3. Set upper part of housing aside, being sure not to touch the electronics when doing so.
4. Hold the lower part of the housing up to the selected position and mark the 3 mounting holes. Make sure that the
wall surface is as even as possible so that the housing does not become distorted when it is screwed on.
5. Using a drill and size 6 bit, drill 3 holes at the points marked on the wall and push in the plugs.
6. Insert the upper screw and screw it in slightly.
7. Fit the upper part of the housing and insert the other two screws.
8. Align the housing and tighten the three screws.
Before working on the unit, switch off the
power supply and secure it against being
switched on again! Check for the absence of
power! Electrical connections may only be
made by a specialist and in compliance with
the applicable regulations. Do not use the
controller if the housing shows visible damage.