Free Hot Water Freedom 5002, Инструкция по установке, эксплуатации и обслуживанию

Страница: 42 / 59


Page 42
Examples of key controller functions:
+/-
= enlarge/shrink values
▼
/
▲
= scroll menu down/up
yes/no = approve/reject
Info
= additional information
Back = to previous screen
ok = confirm selection
Confirm = confirm setting
Setup Wizard
The first time the controller is turned on and after the language and time are set, a query appears as to whether you
want to parametrise (establish parameters) the controller using the commissioning help or not. The commissioning
help can also be terminated or called up again at any time in the special functions menu. The commissioning help
guides you through the necessary basic settings in the correct order, and provides brief descriptions of each
parameter in the display. Pressing the “esc” key takes you back to the previous value so you can look at the selected
setting again or adjust it if desired. Pressing the “esc“ more than once takes you back step by step to the selection
mode, thus cancelling the commissioning help. Finally, menu 4.2 under operating mode “Manual” should be used to
test the switch outputs with the consumers connected, and to check the sensor values for plausibility.
Then switch on automatic mode.
Menu sequence and menu structure
The graphics or overview mode appears when no key has been press for 2 minutes, or when the main menu is
exited by pressing “esc“. Pressing a key in graphics or overview mode takes you directly to the main menu. The
following menu items are then available for selection there:
1. Measurement - Current temperature values with explanations
The menu “1. Measurement values” serves to display the currently measured temperatures.
The menu is closed by pressing “esc” or selecting “Exit measurement values”. Selecting “Info” leads to a
brief help text explaining the measurement values. Selecting “Overview” or “esc” exits the Info mode. If
“Error” appears on the display instead of the measurement there may be a defective or incorrect
temperature sensor.
a.
2. Statistics - Function control of the system with operating hours, etc
The menu “2. Statistics” is used for function control and long-term monitoring of the system.
The menu is closed by pressing “esc” or selecting “Exit statistics”. Please note that the clock does not
continue to run if the mains voltage is interrupted, and must therefore be reset.
3. Display Mode - Select graphics mode or overview mode
Menu “3. Display mode” is used to define the controller’s display for normal operation. This display appears
whenever two minutes go by without any key being pressed. The main menu appears again when a key is
pressed. The menu is closed by pressing “esc” or selecting “Exit display mode”.
4. Operation Mode - Automatic mode, manual mode or switch unit off
In menu “4. Operating modes” the controller can either be placed in automatic mode, switched off, or
placed in a manual operating mode. The menu is closed by pressing “esc” or selecting “Exit operating
modes”.