F3Dn Service Manual Parts Replacement / Section 2.20
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
2.20 Hopper Rotor Replacement
[Part No. 19000246]
1)
The F3Dn Dispenser should be OFF and the freezer
compartment fully defrosted before proceeding.
2)
Open freezer door and remove the Hopper in question.
Place it on its side, with the bottom rectangular opening
for the rotor facing up.
3)
Inspect rotor for damage or excessive wear. If the rotor
does not turn easily by hand, it may need to be replaced.
4)
The rotor front can be identified by the manual rotor
handle molded into the rotation axle. The back support
axle doesn’t have this handle.
5)
Remove the old rotor by gently prying out the plastic
Hopper side closest to the manual rotation handle. When
that handle clears the hole in the Hopper, pry out the
rear side of hopper so that hub clears that hole. Pull up
and carefully remove the rotor from the hopper.
6)
Install the new Rotor [P/N 19000246] by reversing this
process. Make sure the rotor end with the manual
rotation handle faces the front of the Fry Hopper.
7)
Test
the replacement Rotor by:
8)
Manually turn or spin the Rotor Handle. The rotor should
revolve easily, with little resistance.
9)
Replace the Hopper in the freezer compartment and
return the unit to service.
[Photo 1]
A finned rotor is mounted inside
each Hopper to gently move
frozen fries to the Product
Chute.
[Photo 2]
When removing the Rotor, use a
large screwdriver or flat pry bar
to gently lever the sides of the
Hopper enough free to the rotor.
Rev. 1 6/06
Ø
