F3Dn Service Manual Parts Replacement / Section 2.7
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
2.7 Door Lift Motor Replacement
[Part No. 19000161]
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull power cord plug.]
3)
Remove two screws securing service access panel.
4)
Disconnect motor harness power connections from the
[lower] Door Lift Motor.
5)
Using a 5/32” [4 mm] Allen/hex wrench, remove the four
motor mounting screws. [They are all the same length.]
6)
Carefully remove the motor and gearbox assembly from
the machined aluminum Slide Bearing Assembly.
7)
Install the new Door Lift Motor Assembly [P/N
19000161]. Make sure the gear box output shaft fits into
the slot in the lift cam.
8)
Replace and tighten the four mounting screws using your
5/32” [4 mm] Allen wrench.
9)
IMPORTANT
- Check the gap or calibration of the load
cell [weighs basket contents] under the motor by
inserting a .020” [.50 mm] feeler or gap gauge between
set post on left [open] side of load cell. [See Photo 3]
10) If load cell gap is larger or smaller than .020” [.50 mm],
carefully adjust gap set nut located below left side of load
cell.
11) Attach power service wires to new Door Lift Motor. [Red
= positive, Black = negative]
12) Plug in unit power cord to power supply.
Test
the replacement Door Lift Motor as follows:
13) Turn on main power switch & pressing LANE-POWER
touch pad on control overlay.
14) If LOAD READY light is on, position empty fry basket
under hopper to activate fry loading cycle in AUTO
Mode. In MANUAL Mode press MANUAL DISPENSE
touch pad.
15) If Lane properly dispenses fries, it is working properly.
16) Close rear service access panel and return F3Dn
Dispenser to normal operating location.
[Photo 1]
Disconnect power leads from
[lower] Door Lift Motor.
[Photo 2
]
Remove the four motor mounting
screws.
[Photo 3]
After replacing motor, check the
gap on the load cell using a
.020”/.50 mm feeler or gap
gauge.
Rev. 1 9/06
Ø
