F3Dn Service Manual Advanced Troubleshooting Guide / Section 1.3
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
The Problem
Possible Cause
What To Check & Do
Load Size Setting?
Is Load Size selection on Operator’s Panel as
desired? Yes = Continue… No = Change Load Size
selection to desired basket fill level.
Rubber Product
Baffle?
Is rubber baffle assembled inside hopper? If YES =
continue… No = find and insert it. [Note: See
Operating Manual for assembly directions.]
Product Chute
Alignment?
Is metal Product Chute (funnel shape) assembled
below hopper and positioned above dispense doors
correctly? Yes = Continue… No = Reassemble
Product Chute per Operating Manual instructions.
Freezer Bottom
improperly installed?
Is Freezer Bottom assembled inside freezer upside
down or backwards? Yes = Remove freezer bottom
and install per Operating Manual instructions. No =
Continue…
Loose fries buildup?
Is small gap between outside of Product Chute and
plastic Freezer Bottom clear of loose fries and other
debris? Yes = Continue; No = Clean out loose fries
and reassemble Freezer Bottom and Product Chute
per Operating Manual instructions.
Load Cell Calibration?
Follow Load Cell Calibration Procedure per
Section
3.7
. Did this procedure correct problem of “Too
Many Fries”? Yes = Return unit to service. No =
Continue…
Wrong Load Size:
Too Many Fries
Dispense Door
up/down movement?
Check Dispense Door Slide Assembly for free
up/down motion; if any signs of component
corrosion are evident, replace slide assembly per
Section 2.4
or replace complete Automation
Assembly per
Section 2.3
. Did this procedure
correct problem of “Too Many Fries”? Yes = Return
unit to service. No = Contact Franke Service
Department for more troubleshooting options at:
1-800-537-2653, option 5.
Rev. 1 12/06
