F3Dn Service Manual Parts Replacement / Section 2.6A
Questions? Call Franke Technical Support Group For Your Area. Copyright
©
2007 Franke, Inc. All rights reserved.
2.6A Drum Rotor/Motor Block Replacement
[Kit No. 18001678]
–
Kit Contents – See Page 2
1)
Roll unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull power cord plug.]
3)
Remove screw securing rear service access panel.
4)
Disconnect both motor harness power connections.
5)
Using a 5/32” [4 mm] Allen Wrench, remove and discard
the four motor mounting screws.
6)
Remove motor by pulling straight out. Motor rotor block
will remain in place.
7)
From front of unit open freezer door and remove the fries
hopper.
8)
Using a flat blade screwdriver pry off and discard the
existing rubber shaft seal.
9)
Using a 7/16” [11 mm] socket or box wrench, remove
and discard the four block mounting bolts.
10) From rear of unit remove and discard the old rotor block
and shaft assembly.
11) Assemble new contoured block and shaft assembly.
NOTE
: Motor notched end of shaft goes in block first.
12) Insert rotor block with shaft in mounting position.
13) From front of unit insert and tighten the four M6 mounting
bolts using 10 mm socket or box wrench. [
NOTE
: If
needed, have someone brace or hold block from back.]
14) Take foam gasket from Kit, remove paper from adhesive
back, slide over protruding block and stick to unit back
panel. Gasket should be snug against contoured block.
15) Take new shaft seal from kit and push over flattened
hopper/rotor side of shaft until it seats in slot and is tight
against rear of freezer compartment.
16) From rear of unit install the Drum Rotor Motor using a
5/32” [4 mm] Allen Wrench and the four new bolts
provided. Ensure motor gear case drive shaft engages
rectangular slot in plastic Rotor Drive Shaft.
17) Reattach electric power leads to motor terminals: [Red =
positive, Black = negative]
18) Return fries hopper to operating position inside freezer.
19) Reconnect unit to power supply.
20)
Test
for proper motor/shaft/rotor operation by:
21) Turning ON main power switch & pressing LANE-
POWER touch pad on front control overlay.
22) If LOAD READY light is on, position empty fry basket
under hopper to activate loading cycle in AUTO Mode. In
MANUAL Mode, press MANUAL DISPENSE touch pad.
[Continued…]
[Photo 1- From Rear of Unit]
Disconnect both rotor motor
power leads.
[Photo 2 – From Rear of Unit
]
Remove the four motor
mounting screws.
[Photo 3 – From Unit Front
]
Remove and discard the four
block mounting bolts.
[
Photo 4 – From Unit Front]
Cut or pry off shaft gasket and
discard.
Issued 11/07
