Getting Set Up
21
latching footswitch were connected but the type is incorrectly set to momentary then the preset
would only change every other time the pedal was depressed as it would interpret the first press as
the pedal being depressed and the second press as the pedal being released.
If the pedal type is set to continuous it CANNOT be used to control bypass or preset change. This
prevents unwanted behavior in the event the I/O setup is not exact.
Pedal Setup Parameters
PEDAL1 TYPE -
Chooses the type of pedal: continuous, momentary or latching.
PEDAL2 TYPE -
Chooses the type of pedal: continuous, momentary or latching.
PRESET INCR -
Chooses which pedal to use to increment the preset. When the selected pedal is
depressed the next preset will be recalled.
PRESET DECR -
Chooses which pedal to use to decrement the preset.
PRESET START/END -
When using a footswitch to control preset increment/decrement the preset
recalled will range between these values, wrapping around at the limits. For example if you wish to
use a single footswitch to change presets you could plug it into
PEDAL 2
and set
PRESET INCR
to
PEDAL2
. Each time you press the footswitch the preset will increment by one until the
PRESET
END
value is exceed in which case it will jump to the
PRESET START
value. If you wish to cycle
through presets 10 through 14 you would set
PRESET START
to
10
and
PRESET END
to
14
.
PEDAL1 CAL -
To calibrate a continuos pedal connected to
PEDAL 1
press
ENTER
and move the
pedal through its full range several times. Press
ENTER
again when finished.
PEDAL2 CAL -
To calibrate a continuos pedal connected to
PEDAL 2
press
ENTER
and move the
pedal through its full range several times. Press
ENTER
again when finished.
