Fourier DataNet, Руководство пользователя

Страница: 101 / 212

91
Leave Network
If this option is selected, the unit will first leave the network
and then reset itself. The scan network procedure described
in section
3.12.3 will begin. The only exception to this
procedure is that even if the last connected network is found
during the scan, the unit will not automatically connect to it.
Reset Unit
When the unit is reset, upon start up it will automatically scan
for networks. The unit will automatically connect to the
previously connected network assuming it was found in the
network scan.
Turn Off Unit
Selecting this option will shut the unit down. You can turn the
unit on again by pressing the
Scroll button.
It is recommended to turn off the unit when it is not in use.
Note: Turning off the Repeater can have adverse affects on
your network, as other units may be dependent on the
Repeater for transmitting its data to the Receiver. To prevent
the Repeater from being a point of failure if shut off, ensure
the network is robust enough by having alternative routes for
the end units to reach the Receiver.
Turn off unit
Leave network