FOR-A MV-1600, Руководство по эксплуатации

Страница: 60 / 88

4
1-4. Command Protocol Format
The command format is shared for LAN and RS-232C interfaces. Commands are issued by the
control device as shown below.
All command contents are transmitted and received in ASCII code. Use the specified formats
when making and sending message commands. The command format is shown in the table
below.
Command Format
Command code
+
Command parameter
+
CR
+
LF
(2 bytes) (Set in the relevant byte number)
(Works without LF as well)
Ex.: When sending a command to switch channels
Byte Parameter Command Description
1 S
2
Command code
C
3-4 Camera channel 01–16 Channel no.: switch to CH1–16
5 CR
6
End code
LF
IMPORTANT
The MV-1600 sends a response or message after receiving a command. Do not send
the next command before receiving a response or message transmitted by the
MV-1600. Otherwise, the command cannot be read properly.