Website
22
•
New Added item: Set Failsafe for all channels set to
fixed values. With this function, With this function, you
can set the output values of all channels controlled by
a control to the current value, and this value will be
output when the system is losing control.
Set i-BUS-out & PPM to No Output
After the Set i-BUS-out&PPM to no output is enabled,
regardless of the setting of the failsafe, these two types of
failsafe signals are always no output.
Function Settings:
If the check box next to option is not ticked (
√
), it indicates
that the function is disabled.
Channel 1~Channel 18
Used to set the output signal states of channels 1~18
respectively:
No output
means the PWM channel interface
is no output in case of out-of-control;
Hold
means the last
channel value is kept in case of losing control;
Fixed value
means the configured channel value is output in case of
outof-control.
Function Settings:
Set All Fixed Value Channels
Used to set the output value of all channels controlled
by a control that has been set to a fixed value after out-of-
control.
Function Settings:
1. T
ap the channel and enter the next level menu.
2. T
ap to select the desired function options. If the fixed
value is selected, turn the
Stick
(
Switch
,
Knob
or
LSW
) to
the desired position and hold it, and click
to return. The
settings are finished.
Tap this function while holding the control, after that a
prompt menu comes along with it. Click
Yes
to finish.
This function is used to test whether the transmitter
and receiver RF are working properly. As the actual
remote control distance between the transmitter
7.4.4 Range Test
