Website
32
1. Connect the FS-CTM01 sensor to the
NPA
interface of the
receiver.
2. Use soft double-sided tape to attach the FS-CTM01 to
element you want to measure (e.g., motor, battery). Make
sure the sensor is pressed against the surface snugly.
3. At the transmitter side, access
Display sensors
via
Sensors
, if the temperature is displayed, then the
installation is successful, otherwise repeat the above.
1. Connect the FS-CVT01 sensor to the
NPA
interface of the
receiver.
2. Insert the red and black wire pins into the port on the
battery. Red is positive and black is negative.
3. At the transmitter side, access
Display sensors
via
Sensors
, if the
Ext voltage
is displayed, then the
installation is successful, otherwise repeat the above.
1. Connect the FS-CAT01 sensor to the
NPA
interface of the
receiver.
2. Use double sided soft tape to snugly fix the FS-CAT01
receiver in place.
3. At the transmitter side, access
Display sensors
via
Sensors
, if the
Altitude
is displayed, then the installation
is successful, otherwise repeat the above.
Function Settings:
Function Settings:
Function Settings:
Note:
Temperature
means the sensor is testing the temperature.
26.4° C
is the measured value.
Note:
Ext voltage
means the sensor is testing the voltage.
3.2V
is
the measured value.
Note:
Altitude
means the sensor is testing the altitude.
133m
is
the measured value.
FS-CVT01 voltage acquisition module
The FS-CVT01 function is used to monitor the model
battery voltage. Connect it to the NPA interface of the
receiver directly. You can set the alarm value.
FS-CAT01 altitude pressure module
The FS-CAT01 detects the altitude of the model using air
pressure.
