Website
33
1. Connect the FS-CAT01 sensor to the
NPA
interface of the
receiver,
then place the model on the ground.
2.
Use + or – to adjust the altitude
.
Touch the box to the right of the channel name to toggle
reverse for that channel. If there is a tick in the box it means
that the channel is reversed.
Function Settings:
Function Settings:
7.5.3 Air Pressure Sensor
Calibrates ground pressure.
Note: Make sure your model is always at a level ground level
during setup.
7.6 Reverse
7.7 Endpoint
This function reverses the direction of motion for each channel. This function can be used to correct the direction
of the servo action which is opposite to the intended operation.
Changes the max range of movement and the movement range limitation(minimum value, maximum value) for
each channel.
End
is used to set the max of movement value for the travel range of the servo.
Range
is used to set the limited
value for the travel range. After
Range
is set, even if the mixing function increases the travel value of the servo, the
servo movement range will not exceed the range value, thus to protect the servo.
When the servo neutral position deviates too much from the position required for the configuration, the position
adjustment will not achieve a desired effect by this function. Please adjust the servo neutral position first.
With this function, you can adjust the maximum servo movement of 18 channels respectively.
Notes:
1. If a new model is connected make sure that all the servos are
moving in the right direction.
2. Move each stick to make sure that the control surfaces are
moving in the correct directions.
The gray areas are for the set UP
and DW(down) ranges.
The green triangles are for the set
up and down endpoints.
Tap to select the DW End.
