Website
30
7.5.2 Choose Sensors
This function is used to set the sensor data displayed on
the main interface, and to enable setting the current sensor
alarm threshold.
The following descriptions are installations and function
settings about some i-BUS sensor modules.
Take the FGr12B receiver and the PL18 EV transmitter as
an example, connect the sensor to the NPA interface of the
FGr12B receiver, and the other sensor can be connected
to the IN interface of this sensor in turns. The connection
digram between the senor and the receiver is shown below.
Function Settings:
1. Tap a item from the list and enter its menu.
2. Tap to enable the alarm function as well as setting
a customize alarm value. Click the item you want to set,
then it will highlight in light green.
3. Click + or - to set the alarm value.
4. If you want to display the data of external sensors, click
Sensor
column to enter next level menu, then select an
appropriate sensor.
Note: Once any sensor is set, the system will clear the default
sensor and sensor data, showing only the current sensor and
sensor data.
Enable/disable switch.
FS-CPD02
FS-CTM01
FS-CVT01
FS-CAT01
FS-CPD01
FGr12B
Note:
1. The abbreviations for the Newports are for
NPA
,
NPB
,
NPC
and
NPD
, the receiver supports up to 4 newports.
2. For classic receivers, connect the sensor to the SENS
interface of the receiver.
