FLENDER DX2000+, Руководство по эксплуатации

Страница: 41 / 82

S6300-01en Edition 10/2022 41
Assembly
5
5.1 Introduction
5.1 Introduction
Every person who is assigned to work on or with the CMS must have read and un-
derstood these instructions in full.
Ensure that each person follows all safety information.
The operator must ensure that the control cabinet and the DX site server are sup-
plied with power.
Place the control cabinet and the DX site server unpacked at the assembly site.
WARNING
Warning against serious injuries
Unsuitable fastening elements can cause the control cabinet and the DX site
server to come loose.
• Only use suitable fastening material.
• Tighten screws only to the permissible tightening torque.
• Use a torque spanner.
5.2 Assembly of the control cabinet and DX site server
5.2 Assembly of the control cabinet and DX site server
DANGER
Life-threatening injuries possible
Improper installation may result in electric shock, for example.
• As the operator, only allow installation work to be carried out by qualified personnel
trained for this purpose.
• Pay attention to the floor conditions in the working and traffic areas.
• Floor level, recessed and covered drains, trip hazards marked in black and yellow.
• During installation, maintain an access distance of at least 600 mm, preferably 800
mm.
• Maintain the access distance during installation. For passages with pedestrian traffic of
more than one person, the access distance shall be at least 1,000 mm.