11
ARPEX 8706 en
Operating instructions 10/2017
DANGER
Danger to life through switchedon installation
Risk of being caught or drawn in by rotating and/or movable parts.
To carry out work on the coupling, the system must always be stopped. The drive unit must be secured
against being switched on accidentally (e.g. by locking the key switch or removing the fuses from the
power supply).
A notice should be attached to the ON switch stating clearly that work is in progress.
At the same time the complete installation must be without load, so that no danger occurs during
demounting operations.
WARNING
Risk of serious injury through rotating components
Risk of serious injury through contact with rotating components.
The coupling must be fitted with suitable safeguards to prevent any contact. The operation of the
coupling must not be impaired by the safeguard. This also applies to test runs and when checking the
direction of rotation.
WARNING
Risk of serious injury through flying fragments
Risk of serious injury through flying fragments and/or risk of damage to the coupling.
If any malfunctions or changes are noticed during operation, the drive assembly must be switched off
at once.
Note
If the coupling is fitted in plant or equipment, the manufacturer of such plant or equipment must ensure
that the contents of the present instructions are incorporated in his own instructions.
WARNING
Risk of serious injury through flying fragments
Risk of serious injury through flying fragments and/or risk of damage to the coupling through use of
defective spare parts.
Flender guarantees only the genuine spare parts supplied by Flender.
Nongenuine spare parts have not been tested or approved by Flender. Nongenuine spare parts may
alter technical characteristics of the coupling, thereby posing an active or passive risk to safety.
Flender will assume no liability or guarantee for damage caused by spare parts not supplied by Flender.
The same applies to any accessories not supplied by Flender.
