© 1999-2007 QualityWaterForLess.com
- 2 -
Preface:
Thank you for your purchase of a new Water Softener with Fleck 9100SXT Meter from
QualityWaterForLess.com! We have put together these instructions as reference, and to
be used as general installation guidelines. It is always recommended that a licensed
plumber perform all installation work according to all local codes. We at
QualityWaterForLess.com cannot assume responsibility for improper installation,
application, injury, or damage as a result of improper installation.
Pre-Installation Guidelines:
Before assembly of your new system, be sure that the following conditions have been met
for placement of your system:
•
Level, firm surface, such as concrete, on which to place the softener tank and salt
tank (as known as a ‘brine’ tank)
•
Nearby floor drain or standpipe to connect to the softener for use during each
regeneration
•
Un-switched power source, standard US plug, 120v 60hz (the softener system
includes a 5ft. power cord and plug)
•
Access to the water main coming into your home. You will need to install the
softener at this point to assure that water for the home is going through the
system.
Placing and Filling the Tank:
•
Choose the final location for your water softener tank, and place the tank upright
and level on the surface.
•
Filling the tank may be necessary on some systems.
Your tanks may have also
come prefilled
, and in this case you only need to unscrew the protective cap as
shown below in Figure 1 and move on to the next section.
FIGURE 1
